河北辰力FF01拴紧器

★可以根据实际需要配置末端挂件（双排钩、三角环等）

★严禁用于起吊货物使用

★严禁超载使用

★使用环境温度一般为-40℃至+100℃

★长期暴晒的拴紧器强度会有所下降，因此拴紧器不应在长期暴晒在紫外线的环境下使用

★避免在熔炼金属、酸性、玻璃板、易碎物品、核反应堆以及其他一些特殊场所使用

★使用前拴紧器至少围绕固定器的棘轮轴部旋转9/4圈

★标准长度为8米，可以蜘蛛10到50米，适用范围-40℃至+100℃

★使用没有损坏的拴紧器

★不要将织带打结

★可以使用保护套使织带原理锋利棱角，免收磨损或切割

★避免扭曲、拧绞拴紧器

★不要将重物放置在拴紧器上，这样会导致危险

You can according to the actual need to configure the terminal Pendant (double hook, triangle ring etc.)

It is prohibited for lifting goods use

It is strictly prohibited to use overloading

By using the environment temperature of -40 DEG C to +100 DEG C

Fasten the strength. The long-term exposure will decrease, so the device should not be fastened in the long-term exposure in ultraviolet radiation environment

You avoid the use of metal smelting, acid, glass plate, fragile, nuclear reactors and other special places

It is fastened before use around at least fixed for the ratchet shaft rotation circle 9/4

This standard length of 8 meters, can spider 10 to 50 meters, the applicable range of -40 DEG to +100 DEG C

It is no use to fasten the damage

I will not tie the ribbon

You can use the principle of protective sleeve ribbon sharp edge, free of wear or cutting

I avoid distorted, twisted fasten device

I do not place heavy objects in the fastening device, it will cause danger